The majority of the updates after that were for feature additions. However, those issues were taken care of by rev 3.01. Some older revisions of the SFIO chip had exactly the problems you are having. Only twice have I first connected the batteries first by accident and when that happens the connection sparked on the metal clip on the top of battery that you connect battery wires to. When powering up, plug in the panel first then when the cold start trouble clears plug the batteries. The battery gets disconnected first then unplug the panel. The wire connections were stripped a while ago so no copper is touching the board or other wires on the same terminal? The only thing I did the last few weeks was unplug the panel to add devices or move around horn strobes. So I hope this is fixable without a new SFIO board. I have an EST iO 1000 panel next to it and it acts fine. Other than that the panel works as it’s supposed to. Sometimes the N2 trouble stays for a couple of hours or until I reset the panel. All those troubles last a few seconds and the panel is back to normal.
Trouble shoot prizmo 4010 manual#
Recently it sometimes randomly crashes with “Crash Code #11”? I looked in the trouble shooting manual and all that Crash Code 11 says is Invalid config check Programmer or something like that? Some days it behaves just fine and others it gives those troubles multiple times a day. M1-3 is a ZAM module that monitors three conventional pull stations. Then it got worse with “IDNet card missing”, “NAC power card missing” and also “M1-3 Open Circuit trouble”. The panel was bought new with all components and manuals. The most common one is the"External N2 Trouble", the N2 terminal has a resistor in it and I have never moved it since I got the panel. So I’ve had my 4010 for a couple months now and for the last few weeks it’s been giving random troubles on and off.
0 kommentar(er)
